Skip to Content

All Axis Over Travel - FANUC OM

Upon power-up of my Kitamura MyCenter 1 all axis show over travel limit error in the minus direction. The axis are not on limit switches, in fact they are all closer to the plus switches. With this error the axis will only move plus.. I have checked the panel and all switches seem to be fine. Also all limit switches seem to be ok. Does anyone have another suggestion?

Its probably a software over travel.

Its probably a software overtravel. Depending on which control it is you have to do different things on power up. Which fanuc control is it? One thing you can also do is power down the machine and move the axis to get the machine to at least over travel which I believe in that case it will reset the softovertravel limits after zero return.